SMC Networks SMC TigerStack II SMC6624M - Manual (Page 204)

9-34
Configuring Advanced Features
Stack Management
Co
nf
ig
u
ri
ng Adva
nce
d
Feat
u
res
Figure 9-26. Example of the Commander’s Show Stack Screen with Only the
Commander Discovered
Using a Member’s CLI to Convert the Member to the Commander of a
New Stack.
This procedure requires that you first remove the Member from
its current stack, then create the new stack. If you do not know the MAC
address for the Commander of the current stack, use
show stack to list it.
Syntax: no stack
stack commander
Suppose, for example, that an SMC6624M named “Bering Sea” is a Member of
a stack named “Big_Waters”. To use the switch’s CLI to convert it from a stack
Member to the Commander of a new stack named “Lakes”, you would use the
following commands:
The stack commander command
configures the Commander and names
the stack.
The Commander appears in the stack as Switch
Number (SN) 0.