Speco Technologies DVR-T4IP - Manual (Page 47)

47
3.3.8.2 Prohibition setting
Set up prohibition time to transmit the e-mail. Users can enter prohibition time from the
starting time and the ending time of transmitting the e-mail
3.3.8.3 SMTP Server IP address
Configure the IP address of the SMTP server to transmit the e-mail.
If you do not know your SMTP server IP address then go to Command Prompt in Windows,
then use ping and SMTP name address eg mail.specotech.com as below to get your SMTP IP
address. (Same method also applies to finding FTP server IP address from FTP name
address).
(Please note IP 209.35.183.211 is only for Speco Technologies' employees and will not work for
your set-up).
C:\>ping specotech.com
Pinging specotech.com [209.35.183.211] with 32 bytes of data:
Reply from 209.35.183.211: bytes=32 time=342ms TTL=114
Reply from 209.35.183.211: bytes=32 time=344ms TTL=114
Reply from 209.35.183.211: bytes=32 time=347ms TTL=114
Reply from 209.35.183.211: bytes=32 time=350ms TTL=114
Ping statistics for 209.35.183.211:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 342ms, Maximum = 350ms, Average = 345ms
Users can select authentication process dependent on SMTP server requirement.
Selects on/off for authentication process do authentication process whenever transmitting e-
mail messages through SMTP server.
3.3.8.4 Authentication
Users can select authentication process dependent on SMTP server requirement.
Selects on/off for authentication process do authentication process whenever transmitting e-
mail messages through SMTP server.