beautypg.com

Electronic analogue clock (only on some models), 1 setting the time, 2 minute-minder – Smeg SDO10 User Manual

Page 5: Instructions for the user

background image

Instructions for the user

7

5. ELECTRONIC ANALOGUE CLOCK (ONLY ON SOME MODELS)

The programmer user instructions are valid only for the

large oven.

LIST OF FUNCTIONS

MINUTE-MINDER BUTTON

AUTOMATIC LENGTH / SWITCH-OFF TIMING BUTTON

TIME SETTING AND RESET

VALUE DECREASE BUTTON

VALUE INCREASE BUTTON

5.1

Setting the time

When the oven is used for the first time, or after a power blackout, the display flashes on and off at

regular intervals. Press the

key for 1/2 seconds to stop the display flashing and start setting of the

current time. Press the value modification keys

or

to increase or decrease by one minute for

each time a key is pressed.
Press one of the two value modification keys until the current time appears. The clock will start from
the time set 6/7 seconds after the last key is pressed.

At the end of each programmed cooking operation, the clock gives 8 beeps, repeated 3/4 times at
intervals of about 1 and a half minutes. The beeps can be stopped at any moment by pressing any
key.

5.2

Minute-minder

This function does not stop cooking but just triggers the beeps.

-

When the

key is pressed the display illuminates, appearing as shown in

figure 1;

-

Press the

or

keys within 6/7 seconds to set the minute-minder.

Whenever a key is pressed, 1 outside segment, representing 1 cooking minute
will light up (figure 2 shows 10 cooking minutes).

1

-

The countdown will start 6/7 seconds after the last key is pressed; at the end of
it, you will hear the beeps.

-

During cooking with countdown, the current time can be displayed by pressing

the

key once; press again to return to the minute-minder display.

2

-

At the end of the countdown, the oven has to be switched off by hand, by
turning the thermostat and the function selector to 0.