Sanyo PLC-WL2503 - Manual (Page 67)

67
The image is distorted or runs off . – Check PC adjustment Menu or Screen and adjust them.
See pages 31-32, 35-36.
PIN code dialog box appears – PIN code lock is being set. Enter a PIN code (the “1234” or numbers
at start-up . you have set). See pages 19, 55-56.
The Remote Control does – Check the batteries.
not work . – Make sure no obstruction is between the projector and remote
control.
– Make sure you are not too far from the projector when using the
remote control. Maximum operating range is 16.4'(5 m).
– Make sure the code of the remote control is conformed to the
projector’s code. See page 54.
– Unlock the Key lock function for the remote control function.
See page 55.
Indicator blinks or lights . – Check the status of the projector with referring to "Indicators and
projector Condition". See page 70.
The exclamation mark appears – Your operation is invalid. Operate correctly.
on the screen .
Top control does not work . – The top control is not available if the top control is locked at Key lock
under Security of SETTING section. See page 54.
Unable to unlock the Logo PIN – Contact the dealer where you purchased the projector or the service
code lock or Security PIN center.
code lock .
Appendix
WARNING :
High voltages are used to operate this projector . Do not attempt to open the cabinet .
If problems still persist after following all operating instructions, contact the dealer where you purchased the
projector or the service center. Specify the model number and explain about the problem. We will advise you
how to obtain service.
This symbol on the nameplate
means the product is Listed
by Underwriters Laboratories
Inc. It is designed and
manufactured to meet rigid
U.L. safety standards against
risk of fire, casualty and
electrical hazards.
The CE Mark is a Directive conformity
mark of the European Community (EC).
Pixelworks ICs used.
Licensed under USP5,717,422 USP6,816,141