Sanyo PLC-WL2503 - Manual (Page 23)

23
Focus Adjustment
Auto setup function is provided to automatically execute
the setting of Auto setup (includes Input search and Auto
PC adj. functions) in the Setting Menu by just pressing the
AUTO SET button on the remote control. Refer to page 45
for the setting of the Auto setup function.
 Note:
Fine sync, Total dots, Horizontal and Vertical position
of some computers can not be fully adjusted with the Auto
PC adjustment function. When the image is not provided
properly with this operation, manual adjustments are
required. (pp.31-32)
Auto Setup Function
Basic Operation
Press the KEYSTONE button on the remote control or on
the top control. The Keystone dialog box appears. Use
the Point ▲▼ buttons to correct keystone distortion. The
keystone adjustment can be stored (see page 46).
Reduce the upper width
with the Point
▲ button.
Reduce the lower width
with the Point
▼ button.
• The white arrows indicate that there is no correction.
• A red arrow indicates the direction of correction.
• An arrow disappears at the maximum correction.
• If you press the KEYSTONE button on the remote
control or on the top control once more while the
keystone dialog box is being displayed, the keystone
adjustment will be canceled.
• The adjustable range is limited depending on the
input signal.
Keystone Correction
Remote Control
HDMI
ASPECT
AUTO SET button
Adjust the lens focus with the focus lever. Focus Lever
Remote Control
HDMI
ASPECT
POINT ▲▼ buttons
KEySTONE button
Top Control
KEySTONE button POINT ▲▼ buttons