Sanyo PLC-WL2503 - Manual (Page 26)

26
Press the NO SHOW button on the remote control to black
out the image. To restore to normal, press the NO SHOW
button again or press any other button. When the projected
image is captured and is set as User in the Logo selection
(p.47), the screen changes each time you press the NO
SHOW button as follows.
black out → the captured image → normal → • • • • •
NO SHOW button
Press the P-TIMER button on the remote control to operate
the Count up/Count down function. Refer to p.52 for detail of
Setting for the P-timer function.
To stop the count time, press the P-TIMER button.
To cancel the P-timer function, press and hold the P-TIMER
button for a few seconds.
P-TIMER button
Press the IMAGE button on the remote control to select a
desired image mode of the screen. See pages 33, 40 for
details.
IMAGE button
No show disappears after 4 seconds.
 Note:
See the previous page for the description of
other buttons.
HDMI
ASPECT
IMAGE button
NO SHOW button
P-TIMER button
SCREEN button
Select the screen size (See pages 35-36, 43 for details).
SCREEN button
Basic Operation
Remote Control
 Note:
When use the MUTE button to release the No Show function,
the mute function can not be operated at the same time.