Sharp FO-DC500 - Manual (Page 19)

Connections
17
1. Installation
Attaching the ADF exit tray
Insert the protrusion on the right side of the machine into the hole in the right
side of the ADF exit tray
➊
, then bend the tray slightly and insert so that the
protrusion on the left side of the machine goes into the hole on the left side of
the ADF exit tray
➋
. Pull out the tray extension
➌
.
Attaching the received document tray
Slide the received document tray into the machine as shown. When it stops,
lift the end slightly and push in so that the tray locks into place.
Important!
The received document tray must be attached for the machine to operate
properly.
1
3
2