Siemens SED2 - Manual (Page 18)

SED2 AOP Operating Instructions
10 Siemens Building Technologies
The AOP display the current status of the SED2 and motor. The following table explains
information on this display.
STOPPED
r0000
I=0.0A
M=0%
F=0.00Hz
RPM=0
V=0.0V
Fn
P
Table 1. Status Information of an AOP Display with an Operating SED2.
Data Description
STOPPED Indicates the motor connected to the SED2 is not running (pulses disabled).
RUNNING Indicates the motor connected to the SED2 is running (pulses enabled).
FAULT
Indicates a fault condition has occurred. The SED2 is not running. A fault, described
by the AOP under the Diagnostics menu, is preventing operation.
WARNING
The SED2 has detected a problem in normal operation and is informing you of the
drive condition.
INHIBIT
A previously occurring fault or OFF condition is preventing SED2 operation. Sending
an OFF1 command from the currently active command source clears this condition.
r0000 Indicates a read-only parameter. Drive Display r0000 is the normal operating display.
F= 0.00 Hz Indicates the frequency at which the SED2 VFD/motor is running.
S= 0.00 Hz Indicates the speed (frequency) when the motor last stopped.
I= 0.0 A Indicates the output current.
RPM= 0 Indicates the speed of the motor.
M= 0% Indicates the current torque of the motor.
V= 0.0 V Indicates the output voltage.
Vdc= 0.0V Indicates the dc link voltage.
and Simultaneously press these keys, at any time, to display the main menu.
and Simultaneously press these keys to display the help screens.
Press P to select the parameter access screen.
and Navigation keys to scroll through information on the display.
Indicates the direction of the running motor.