SIGMA SD14 - Manual (Page 44)

43
USING THE BUILT-IN FLASH
The cameras have built-in flash for taking pictures at night or in low light,
which is very convenient.
USING THE BUILT-IN FLASH
P mode, use this mode for automatic
photography. The flash sync speed and
aperture are set automatically. If the subject is
too dark, the flash indicator ” ” in viewfinder
will blink, then you can take a flash exposure
by following.
1
Grasp the built-in flash (see picture) and lift it
up gently.
2
Wait for the mark to appear in the
viewfinder.
■
When you lift up the built-in flash, it will start charging. While the built-in flash is
charging, the mark is not visible, but when the flash is sufficiently charged,
the indicator in viewfinder and on the LCD panel, will show mark.
■ During the charging, the shutter cannot be released.
■ After you finish using the built-in flash, close the flash head by pressing the top
part of the flash down.
■ When you use the built-in flash continuously, the grip of the camera will
become warm. This is normal and not a defect.
CAUTION !!
•
The lens hood may intrude into the light path of the built-in flash unit,
resulting in a shadow at the bottom of the picture. (The same phenomenon is
possible with a lens, which has a large front lens and long length) Either
remove the lens hood, or use an external Sigma dedicated flash.
•
To prevent overheating and protect the built-in flash unit after using
continous shooting with flash, please do not use your flash for a while,.