Siemens 2000 - Manual (Page 39)

Menu Status
39
Quality of Service (QoS): Monitoring Settings
Navigation: Admin > Quality of Service > Monitoring Settings
Using Quality of Service you can set up error reports for a QCU server and
define the threshold settings.
Send a report (report mode)
Select the mode for report generation:
– EOS Threshold exceeded
A report will be sent at the end of the session only if the threshold
was exceeded.
– EOR Threshold exceeded
A report will be sent at any report interval if the threshold was excee-
ded.
– EOS (End of Session)
A report will be sent at any report interval.
– EOR (End of Report Interval)
At the end of each session a report will be sent.
QCU Server Address
Enter the IP address or DNS name of an QCU-Server (see Æ Addressing a
server).
Report Interval (in sec.)
A QoS report is sent for each report interval if the report mode (Send a
report (report mode) was set accordingly (from 10 to 3600 seconds).
Send to QCU
Select Yes if a QCU server is set up and if the QoS data are to be logged on
this server.
Send SNMP Traps
Select Yes if errors occurring in network components are to be logged.
Minimal Session Length (in 100 ms)
If the session (e.g. a call) is shorter than the defined minimum lenght, no
QoS report is sent.