Adv anced setting up camera system – Samsung Digimax350 SE User Manual
Page 77
ADV
ANCED
SETTING UP CAMERA SYSTEM
VIDEO OUT
The Video output signal from the camera can be NTSC or PAL. Your choice of output will be
governed by the type of machine (monitor or TV, etc.) to which the camera is connected.
Select the correct video standard for the outer monitor. PAL mode can support only BDGHI.
1. Turn the camera on.
2. Rotate the mode dial to SET UP mode ( ).
3. [SETUP 1/3] menu will show on the LCD monitor.
4. Shift the cursor to the [SETUP 3/3] sub menu by
pressing the RIGHT button (
)
5. Press the DOWN button (
) and select [VIDEO OUT].
6. Shift the cursor to the [VIDEO OUT] sub menu by
pressing the RIGHT button (
)
7. Select the desired sub menu by pressing the UP (
) /
DOWN (
) buttons. The default is NTSC.
8. After selecting the desired sub menu, press the OK button to confirm the setting.
SETUP
3/3
BACK :
SET : OK
NTSC
PAL
SOUND
LCD
VIDEO OUT
QUICK VIEW
QUICK VIEW
With QUICK VIEW you can pre-set the camera to briefly review the last image captured. It is possible
to vary the time the image is visible, according to your particular requirements.
1. Turn the camera on.
2. Rotate the mode dial to SET UP mode ( ).
3. [SETUP 1/3] menu will display on the LCD monitor.
4. Select [SETUP 3/3] menu by pressing the LEFT (
) /
RIGHT (
) buttons.
5. Press the DOWN button (
) and select [QUICK VIEW].
6. Shift the cursor to the [QUICK VIEW] sub menu by
pressing the RIGHT button (
)
7. Select the desired sub menu by pressing the UP (
) /
DOWN (
) buttons. The default is 1 second and you
can change it up to 3 seconds.
8. After selecting the desired sub menu, press the OK button to confirm the setting.
SETUP
3/3
BACK :
SET : OK
01 SEC
SOUND
LCD
VIDEO OUT
QUICK VIEW