Samsung Digimax350 SE - Manual (Page 27)

READY
TAKING PHOTOS
Note
Select Macro shot mode when the subject is between 0.2m ~ 0.8m from the camera.
Refer to page 32 for information on Macro shooting.
If you take an image in dark place " LOW LUMINANCE" message will display on the LCD
monitor. In addition, it may cause the camera to fix the focus as listed below.
Normal shot mode : 2.5M Macro shot mode : 0.5M
In this case, increase the lighting value or take an image in a bright place.
If you do not select the correct shot mode appropriate to the distance from the subject to the
camera, you will not be able to obtain a clear shot of the subject.
Avoid obstructing the Flash control sensor when you take an image. An image can be
spoiled when a finger, hair or camera strap is in front of the Flash control sensor.
Using the LCD monitor extensively will drain the batteries. We recommend using the optical
viewfinder as often as possible in order to extend battery life. If the LCD monitor is more
appropriate, switching it off between shots will also help to extend the battery life.
Reference
If there is no card, [NO CARD!] message will show in the LCD monitor.
If there is no card, no buttons will function except for Power button, Mode dial and Zoom
button.
If there is insufficient memory available:
If you press the shutter button halfway for the shot, the following message is displayed
and the camera will not operate.
To optimise the amount of memory in the camera, replace the CF CARD or delete
unnecessary images stored on the CF CARD.
CARD FULL !