Siemens HIPATH 2000 - Manual (Page 88)

Step by Step
Using Other Functions
88
Using System Functions from the Outside
(DISA: Direct Inward System Access)
If this function has been configured (contact your ser-
vice personnel), you can set up external outgoing calls
from outside the system, just like an internal user. You
can also activate and deactivate the following functions
in your system:
• Reset services and functions,
code: #0
Æ Page 86
• Call forwarding, code: * 1/#1 Æ Page 21
• Lock and unlock all phones,
code:
* 66/#66 Æ Page 78
• Save PIN,
code:
* 93 Æ Page 80
• Send a message,
code:
* 68/#68 Æ Page 81
• Leave an advisory message,
code:
* 69/#69 Æ Page 83
• Group ringing, code: * 81/#81 Æ Page 96
• Group call, code: * 85/#85 Æ Page 96
• Suppress caller ID,
code:
* 86/#86 Æ Page 75
• Waiting tone, code: * 87/#87 Æ Page 52
• Open door, code: * 61 Æ Page 36
• Door opener on/off, code: * 89/#89 Æ Page 37
• Control relay, code: * 90/#90 Æ Page 93
• Do not disturb, code: * 97/#97 Æ Page 74
• Ringer cutoff function, code: * 98/#98 Æ Page 74
• Speed-dialing, code: * 7 Æ Page 41
• Associated service, code: * 83 Æ Page 87
Precondition: You have a telephone that uses tone di-
aling (DTMF dialing) or you can switch your telephone
to tone dialing. The telephone is not connected to the
system.
o
Set up a call to the system. Enter the station number
(contact your service personnel).
o
Wait for a continuous tone (if necessary switch the tele-
phone to tone dialing), then enter the internal number
that has been assigned to you and the associated PIN.
r
Enter the code (necessary only if programmed in the
system).