Setting up screen call, Activating screen call, Selecting an announcement for screen call – Sanyo SCP-7050 User Manual

Page 95: Recording name for a pre-recorded announcement

Setting Up Screen Call

This feature enables you to screen incoming calls by using a
recorded announcement, either one that is pre-recorded or one
that you have recorded. You can also record the caller’s message
into the Voice Memo list.

Activating Screen Call

To start Screen Call when you have incoming calls:

ᮣ

When the phone rings or vibrates, press

(right

softkey) > Screen Call.

To set Auto Screen Call:

1. Press (right

softkey) > Screen Call > Auto > On.

2. Set the answer delay by using numeric keys or by pressing the

navigation key up or down.

3. Press

(left softkey). The

icon is displayed on the

Standby display.

Tip:

While the caller’s message is being recorded, press

to answer

the call, or press

to stop recording and disconnect the call.

Selecting an Announcement for Screen Call

1. Press (right

softkey) > Screen Call > Announcement.

2. Depending on your preference, select Pre-Recorded or Custom.

Recording Name for a Pre-Recorded Announcement

1. Press (right

softkey) > Screen Call > Announcement.

2. Highlight Pre-Recorded and press

(right softkey) >

Record Name.

Ⅲ

If your name has already been recorded, select Yes or No
for overwriting.

3. Press

to start the 1st recording. (The maximum recording

time is 12 seconds.)

4. Press

to stop recording.

5. After the 1st recording, press

again to start the 2nd

recording.

6. Press

to stop recording.

Edit

Memo

Options