Sony AIR-SA20PK - Manual (Page 36)

AIR-SA20PK.GB.4-117-793-32(1)
GB
Messages
CANCEL : Time out without pairing.
COMPLETE : Pairing is completed.
ID A : Sets the S-AIR ID to “A.”
ID B : Sets the S-AIR ID to “B.”
ID C : Sets the S-AIR ID to “C.”
LINKED* : The sub unit is connected to
the main unit.
PAIRING : Pairing is in progress.
RMT OFF* : The sub units are not
accepting signals from the remote
because the remote control function is
set to “RMT OFF.”
S-AIR* : Displayed from the point
power of the sub unit is turned on
until connection with the main unit is
established.
TIME NG* : The Daily Timer start and
end times are set to the same time.
UNLINKED* : The connection with the
main unit is cut off.
* Displayed on the sub units only.
Precautions
Notes on use of the S-AIR product
 As the S-AIR product transmits sound
by radio waves, sound may skip when
radio waves are obstructed. This is a
characteristic of radio waves and is not
a malfunction.
 As the S-AIR product transmits
sound by radio waves, equipment that
generates electromagnetic energy, such
as a microwave oven, may interfere
with sound transmission.
 As the S-AIR product uses the radio
waves that share the same frequency as
other wireless systems, such as wireless
LAN or Bluetooth devices, interference
or poor transmission may result. In
this case, take the following steps:
 Do not install the S-AIR product
near other wireless systems.
 Do not use the S-AIR product and
the other wireless systems at the same
time.
 The transmission distance differs
depending on the usage environment.
Find a location where transmission
between the main unit and the sub
units is most effective, and install the
main unit and the sub units there.