Sony AIR-SA20PK - Manual (Page 25)

AIR-SA20PK.GB.4-117-793-32(1)
GB
Oper
ations
To use the main unit as a battery
charger
You can use the main unit as a battery
charger for the iPod when the main unit
is on.
The charging begins when the iPod
is placed on the iPod connector. The
charging status appears in the iPod
display. For details, refer to the user’s
guide of your iPod.
To stop charging the iPod, remove the
iPod or turn off the main unit.
Notes
 When placing or removing the iPod, handle
the iPod in the same angle as that of the
iPod connector on the main unit and do not
twist or sway the iPod to prevent connector
damage.
 Do not carry the main unit with an iPod
set on the connector. Doing so may cause a
malfunction.
 When placing or removing the iPod, brace
the main unit with one hand and take care
not to press the controls of the iPod by
mistake.
 Before disconnecting the iPod, pause
playback.
 You cannot adjust the volume using the main
unit.
 The volume level does not change even if
adjusted on the iPod.
 The main unit is designed for iPod only. You
cannot connect any other portable audio
players.
 Depending on the iPod model you are using
and its status, operations using the main unit
and the sub units may not be accepted or the
wrong operations may be performed.
 Sony cannot accept responsibility in the
event that data recorded to iPod is lost or
damaged when using an iPod with this S-AIR
product.
Listening to the
radio using the S-AIR
connection
Using the main unit
1
Select.the.tuner.channel.
When the S-AIR mode is set to
“PARTY”:
Press PARTY CH on the remote
repeatedly until “FM” or “AM”
appears in the display.
When the S-AIR mode is set to
“MULTI SOURCE”:
The tuner channel is internally
activated. Go to step 2.
2
Select.“FM”.or.“AM.”
Press BAND repeatedly.
3
Perform.automatic.tuning.
Press and hold TUNING +/ on
the remote (or TUNING/SELECT
+/ on the unit) until the frequency
indication changes and then release.
“AUTO” lights up in the display.
Scanning stops automatically when
a station is tuned in, and then
“TUNED” and “ST” (for FM stereo
programs only) appear.
When you tune in a station that
provides RDS services, the station
name appears on the display.
Continued
