Sony AIR-SA20PK - Manual (Page 17)

AIR-SA20PK.GB.4-117-793-32(1)
1 GB
G
etting
.Star
ted
Continued

 Wireless transceiver
Insert the supplied wireless transceiver
(EZW-RT10 or EZW-RT10A) securely
into the EZW-RT10 slot on the rear panel
of each unit.
Check the orientation of the  mark
when inserting the supplied wireless
transceivers (EZW-RT10 or EZW-
RT10A). Failure to do so may result in
damage to the unit.
Notes
 Make sure to turn off the main unit and the
sub units when inserting or removing the
supplied wireless transceivers (EZW-RT10 or
EZW-RT10A). Failure to do so may result in
damage to the unit.
 Do not touch the terminals of the supplied
wireless transceivers (EZW-RT10 or EZW-
RT10A).
 Do not insert any device other than the
supplied wireless transceivers (EZW-RT10 or
EZW-RT10A) into the EZW-RT10 slot.
 S-AIR ID selector
Set the same S-AIR ID for the main unit
and the sub units. For details on setting
the S-AIR ID, see “Establishing the S-AIR
connection” (page 18).
 FM/AM antennas
Find a location and an orientation that
provide good reception, and then set up
the antenna.
Keep the antennas away from the power
supply cord to avoid picking up noise.
 Power
Connect the power supply cord and the
power cord to a wall socket.
To use the iPod
Insert an iPod Dock Adapter into the
iPod connector on the main unit before
use.
For details on the supplied iPod Dock
Adapters, refer to the instructions
supplied with the Dock Adapters.
To remove the iPod Dock Adapter, pull
it up with your fingernail or a flat object
using the slot inside the adapter.
Slot