Sharp UP-820F - Manual (Page 53)

51
The LAN interface for the UP-820F/UP-820N POS enables the UP-820F/UP-820N to perform in-line
communications to a host P.C. through the connection to a Manager Work Station (MWS).
For the setup of the Manager Work Station, please be sure to consult your authorized SHARP dealer.
The function of Manager Work Station:
1) Downloading of the terminal data [Terminal PC]
2) Uploading of the terminal data [Terminal PC]
3) Remote Job Entry (RJE) function [Terminal PC]
4) T-LOG function [Terminal PC]
5) ELECTRONIC MAIL function [Terminal PC]
(1) Programming of the MWS terminal number
The terminal number of MWS can be specified by the following procedure:
1.
Enter the PGM2 mode from the mode selection window.
2.
Select “SETTING” and press the
e
key.
The SETTING window will appear.
3.
Select “MWS CONFIG” and press the
e
key.
The MWS CONFIG window will appear.
4.
Move the cursor to the “IP ADDRESS 4” line.
Enter the terminal number (0-254) in the IP ADDRESS 4 line
of MWS and press the
c
key.
• Entering a terminal number of the machine itself results in
“ENTRY ERROR”.
9. Programming for the Manager Work Station (MWS)
– master and satellite