Sharp UP-820F - Manual (Page 42)

40
For the setup of your IRC system, please be sure to consult your authorized SHARP dealer.
(1) Setting the terminal number for the master and creating the master list
A master list can only be created on the pre-designated master.
1.
Enter the PGM2 mode from the mode selection window.
2.
Select “SETTING” and press the
e
key.
The SETTING window will appear.
3.
Select “INLINE CONFIG” and press the
e
key.
The INLINE CONFIG window will appear.
4.
Enter a terminal number (0–254) for the master in the “IP
ADDRESS 4” line and carry out the programming for BMA
MACHINE No.*, the SYSTEM RETRY function*, and
LOOKUP ORDER* and press the
e
key.
The MASTER LIST window will appear.
(*For programming for BMA MACHINE No., the SYSTEM
RETRY function and LOOKUP ORDER, see pages 42–44.)
5.
Enter the terminal number (1–254) for a machine in the IRC
system and press the
e
key.
The machine number line will appear.
6.
Enter the machine number (1–999999) of the machine and
press the
e
key.
7.
Repeat steps 5 to 6 for all machines in the IRC system.
Press the
c
key to complete the master list.
3. Initial setting for the master and master list creating/updating