Sharp UP-820F - Manual (Page 28)

26
(1) Report generation procedure
To generate various reports, use the following procedure, referring to the list of consolidated reports
on the following pages.
1.
Enter the required operating mode (OPXZ, X1/Z1 or X2/Z2)
from the mode selection window.
2.
Select “SYSTEM READING” or “SYSTEM RESETTING”
depending on your need, and press the
e
key.
3.
Select the type of report you wish to generate and press the
e
key or enter the corresponding report type No.(2-digit)
shown on the display. By selecting an item with parentheses
on the opening screen and pressing the
e
key, you can
jump to the pertinent report list. (If the desired type of report
is not listed on the display, you can scroll up or down the
screen with the scroll keys.)
4.
If you need to enter data to generate a report, follow the
instructions given on the display for entry.
The MACHINE No. window will appear.
5.
If you wish to generate a report on all the machines in the
system, select “ALL” and press the
e
key. If you wish to
generate a report on specific machines, select “MACHINE
SELECT” and press the
e
key. In this case, the MACHINE
SELECT window will open. Move the cursor to the machine
number, select “YES,” and press the
c
key.
The OUTPUT TO window will appear.
6.
Select “DISPLAY” or “REPORT PRINTER” and press the
e
key.
2. Consolidated reports – master/back-up master