Control codes pcos series 150 programmer's guide, Star codes – Star Micronics 150 User Manual
Page 88
Control Codes
PcOS Series 150
Programmer's Guide
STAR Codes
Page 78
Rev G
12/14/99
Control codes used for graphic printing
[ESC] 1
Set 7/72-inch line feed.
[ESC] A
Define n/72-inch line feed.
[ESC] 2
Set n/72-inch line feed.
[ESC] J
Set one-time line feed of n/72-inch.
[ESC] z 0
Set 1/12-inch line feed.
[ESC] K
Set 8-dot single-density bit image.
[ESC] L
Set 8-dot double-density bit image.
[ESC] h 1
Select vertical expanded character mode.
[ESC] h 0
Cancel vertical expanded character mode.
Control codes used for peripheral units
[BEL]
Defer drive command for Peripheral Unit 1.
[EM]
Set immediate drive command for Peripheral Unit 2.
[FS]
Set immediate drive command for Peripheral Unit 1.
[SUB]
Set immediate drive command for Peripheral Unit 2.
Other control codes
[RS]
Activate sound buzzer. 11
[CAN]
Cancel print data in buffer.
[ESC] U 1
Select unidirectional print mode.
[ESC] U 0
Select bidirectional print mode.
[ESC] @
Initialize printer.
[ESC] ! *
End italics.
[ENQ]
Perform inquiry.
[ESC] d 0
Cycle autocutter.12
[ESC] d 1
Cycle autocutter.
[ESC] W 1
Select expanded character mode.
[ESC] W 0
Cancel expanded character mode.
[ESC] y
Set n/144-inch line feed.
[ESC] 3
Set n/216-inch line feed.
11
This command only functions if the internal buzzer option was installed at the factory.
12
The printer can be equipped with either a full or partial cutter option.