Star Micronics 150 - Manual (Page 80)

Control Codes PcOS Series 150 Programmer's Guide
EPOS Codes
Page 70 Rev G 12/14/99
[ESC] < Return home (not necessary with the Series
150 printer).
[ESC] = Not the same Select peripheral device (Pass through).
[ESC] ? Ignored Cancel user-defined characters.
[ESC] @ Initialize printer.
[ESC] B 1 2 3
... i 0 Extension Set vertical tab stops.
[ESC] C Similar Set form length.
[ESC] D 1 2
3 ... i 0 Extension Set horizontal tab stops.
[ESC] E Turn emphasize mode ON/OFF.
[ESC] G Turn double-strike mode ON/OFF.
[ESC] J Print and feed.
[ESC] K Not implemented Print and reverse feed.
[ESC] M Select character font.
[ESC] Q Set right margin in characters.
[ESC] R Select International Character Set.
[ESC] U Turn unidirectional mode ON/OFF.
[ESC] V Similar Turn 90
°
clockwise mode ON/OFF.
[ESC] [ Select code page/print features (same as
normal mode).
[ESC] \
L
>
H
> Set relative print position.
[ESC] ^ ... Set Epson 9-pin bit image.
[ESC] a Set left, center, or right justify.
[ESC] b Print bar code (same as normal mode).
[ESC] c Similar Select station. See description below.
[ESC] d Feed lines.
[ESC] e Not implemented Print and reverse feed.
[ESC] f Similar Set wait time. See description below.
[ESC] I Set full cut.
[ESC] l Set left margin in characters.
[ESC] m Set partial cut.
[ESC] p Similar Generate pulse. See description below.
[ESC] q Release form.
[ESC] t Select Character Code Table (may vary from
Epson Select Code).
[ESC] u Return status of cash drawer (Serial and IEEE
1284 only).
[ESC] v Extension Return null byte to host.
[ESC] x Extension Set print font (same as Normal [ESC] I ).
[ESC] { Turn upside down print ON/OFF.
[ESC] ~ Extension Test mode diagnostic commands.
[GS] ! Select character size.
[GS] I Transmit specified ID (different than Epson).
[GS] L ... Set left margin in 1/160 inch.
[GS] W ... Select printable area in 1/160 inch.
[GS] h Extension Set bar code height.
[GS] k ... <0> Extension Print bar code.