Star Micronics 150 - Manual (Page 20)

General Specifications PcOS Series 150 Programmer's Guide
Page 10 Rev G 12/14/99
Receipt/Journal Paper
Paper-feed method Friction feed
Paper-feed pitch Default - 0.13 inch (1/8 inch or 3.18 mm); can be set in units of
0.0046 inch (1/216 inch or 0.12 mm) by software command
Paper width 2.75, 3.00, or 3.25 inches (69.85, 76.20, 82.55 mm)
Roll diameter 3.50 inches (88.90 mm)
Paper thickness at 25
°
C
Two-ply 0.006 - 0.007 inch (0.15 - 0.18 mm)
Three-ply 0.009 - 0.0105 inch (0.23 - 0.27 mm)
Roll paper core Inside diameter 0.44 inch (7/16 inch or 11.11 mm)
Roll footage (typical)
Two-ply 110 feet (3353 cm)
Three-ply 70 feet (2134 cm)
Receipt-paper out Paper exhaust is sensed by software, and printing is prevented at the
end of the roll.
Printable Area
Receipt Printing
1.00 inch (25.4 mm)
0.46 inch (11.68 mm)
2.34 inches
(59.44 mm)
3.25 inches
(82.55 mm)
Paper tear-off
Figure 4 Receipt printable area
Receipt Printing with the Autocutter
The paper is cut one inch from the last line of print, which minimizes the wasted paper
required when the paper must be moved to the cut-off position.
Validation Forms Printing
Lines per inch (lpi) Lines
8 16
6 12
Table 4 Validation lines