Sanyo PLC-XE33 - Manual (Page 16)

PLC-XE33 Basic Serial Command Specifications
15/22
6.34. ON START Setting Command
Command “C28” [CR]
Detail
Enable Power ON Start.
This status is stored in EEPROM and retained regardless of Power OFF/ON.
Response
Acceptable [ACK] [CR]
Unacceptable “ ”[CR]
6.35. ON START Cancel Command
Command “C29” [CR]
Detail
Disable Power ON Start.
This status is stored in EEPROM and retained regardless of Power OFF/ON.
Response
Acceptable [ACK] [CR]
Unacceptable “ ”[CR]
6.36. Power Management Ready Command
Command “C2A” [CR]
Detail
Set Power Management to Ready mode.
This status is stored in EEPROM and retained regardless of Power ON/OFF.
Response
Acceptable [ACK] [CR]
Unacceptable “ ”[CR]
6.37. Power Management OFF Command
Command “C2B” [CR]
Detail
Set Power Management to OFF mode.
This status is stored in EEPROM and retained regardless of Power ON/OFF.
Response
Acceptable [ACK] [CR]
Unacceptable “ ”[CR]
6.38. Power Management Shut down Command
Command “C2E” [CR]
Detail
Set Power Management to Shut down mode.
This status is stored in EEPROM and retained regardless of Power OFF/ON.
Response
Acceptable [ACK] [CR]
Unacceptable “ ”[CR]
6.39. D.ZOOM + Command
Command “C30” [CR]
Detail
Enter Digital Zoom mode and expand image size.
This command works the same way as “D.ZOOM
▲” button of the remote control.
Response
Acceptable [ACK] [CR]
Unacceptable “ ”[CR]