Sanyo PLC-XE33 - Manual (Page 10)

PLC-XE33 Basic Serial Command Specifications
9/22
6.4. Operation Requirements
1) When the projector’s status is any of below, Functional Execution Commands are limited.
Projector Status Available Functional Execution Commands
Standby Mode C00 POWER ON
Countdown in process
C00 POWER ON → Countdown is terminated
C01 POWER OFF
C02 POWER OFF
→ Countdown is terminated
Cooling Down in process NONE (No Execution)
Cooling Down due to Abnormal
Temperature
NONE (No Execution)
Abnormal Temperature Status NONE (No Execution)
Abnormal Power Status NONE (No Execution)
Power Save / Cooling Down in process NONE (No Execution)
Power Save Status
C00 POWER ON
C01 POWER OFF
Input search On1/On2 setting
Although transmit Input source commands, Input
search does not operate.
Note) When the status is as above, even if the projector receives other commands,
it returns [ACK] [CR].
2) When Eco mode is selected in Standby mode of Setting menu and projector is in Standby,
Functional Execution Commands are invalid.