Backup recording – Sanyo DSR-C100 User Manual

Page 45

Backup recording

If there is 20 minutes or more of available recording time remaining in the post-alarm recording area of the
hard disk after post-alarm recording is completed, backup recording (pre-alarm 2 (PRE2) recording) starts
automatically. It follows from this that if there is not 20 minutes or more of time remaining, backup
recording is not carried out.

Pre-alarm 2 (PRE2) recording starts automatically.

“PRE2-ALARM REC” is displayed.

If an emergency situation develops, press and hold
the H (HOLD-UP) switch.

“POST2-ALARM REC” will be displayed and post-alarm
2 (POST2) recording will start.

When the emergency situation has ended, release the H (HOLD-UP) switch.

“ALARM REC FULL” will be displayed and alarm recording will end.

Note:

When post-alarm 2 (POST2) recording has ended, there will not be any more space available for recording,
and so it will not be possible to continue alarm recording. To re-start pre-alarm recording, transfer the image
data to a computer and then carry out either one of the following two operations.

•

Select “DELETE” from the FUNCTIONS screen, and delete all of the image data. (See page 73)

•

Select “INITIALIZE” from the HDD SET sub-screen of the SETTINGS screen and re-initialize the hard disk.
(See page 24)

PRE2-ALARM REC

REMAIN SHOTS: 6834

PRE2-ALARM REC

REMAIN SHOTS: 6834

POST2-ALARM REC

REMAIN SHOTS: 6834

POST2-ALARM REC

REMAIN SHOTS: 6834

L42A4/US (DSR-C100) GB 2001, 4, 16

English