Sanyo DSR-C100 - Manual (Page 43)

Screen displays
1 Display during recording
• During recording, the screen display will switch off
after 30 seconds have passed. You can make the
screen display re-appear by pressing the SET or
CURSOR button.
• The screen display can be set to switch off immediately
from the start of recording. To do this, set “CAUTION
LED” on the SYSTEM SET screen to OFF. To re-display
the screen, set it back to ON. (See page 23)
2 Number of suspicion recording images
Pre-alarm recording
1
Press the MENU button.
The MAIN MENU screen will be displayed.
If the MAIN MENU screen remains displayed for about
30 seconds, pre-alarm recording will then start
automatically.
2
Use the CURSOR (j or l) button to select
“RECORD START” and then press the SET button.
“PRE1-ALARM REC” will be displayed and
pre-alarm (PRE1) recording will start.
The warning indicator and caution
indicator both light during pre-alarm
recording.
Note: Pre-alarm recording will continue with the images being recorded in the pre-alarm (PRE1) area of the
hard disk until the hold-up switch or suspicion switch at the back of the camera is pressed.
3
Press the MENU button to stop recording.
The display will return to the MAIN MENU screen.
1
2
PRE1-ALARM REC
REMAIN SHOTS: 6834
PRE1-ALARM REC
REMAIN SHOTS: 6834
NTSC
PAL
SET MENU
1 2
(MAIN MENU)
RECORD START
PLAYBACK
SETTINGS
CONDITION
MENU
SET
PRE1-ALARM REC
REMAIN SHOTS: 6834
PRE1-ALARM REC
REMAIN SHOTS: 6834
L42A4/US (DSR-C100) GB 2001, 4, 16
42 English