Sun Microsystems Sun Fire T1000 - Manual (Page 77)

Chapter 3 Removing and Replacing FRUs 65
▼ To Remove DIMMs
Caution – This procedure requires that you handle components that are sensitive to
static discharges that can cause the component to fail. To avoid this problem, ensure
that you follow antistatic practices as described in
“To Perform Electrostatic
Discharge (ESD) Prevention Measures” on page 56 .
1. Perform the procedures described in “Common Procedures for Parts
Replacement” on page 53 .
2. Locate the DIMM (FIGURE 4-8) that you want to replace.
Use FIGURE 3-11 and TABLE 3-1 to identify the DIMM you want to remove.
3. Make note of the DIMM location so you can install the replacement DIMM in the
same socket.
4. Push down on the ejector levers on each side of the DIMM until the DIMM is
released.
FIGURE 3-11 DIMM Locations
TABLE 3-1 maps the DIMM names that are displayed in faults to the socket numbers
that identify the location of the DIMM on the motherboard.