Seiko Instruments DPU-30 - Manual (Page 35)

5-7
5.4.2 Mode 1/Mode 2
1. Basic
command
CR Carriage Return
Code 0D
16
Function Prints the data stored in the print buffer, and then starts a new line according to the
defined amount of paper feed for one line.
Details • After executing this command, a head of a line is set as a starting position of
printing.
• LF command received immediately following CR is ignored.
• The amount of paper feed for one line is fixed at 24-dot pitch.
LF Line Feed
Code 0A
16
Function Prints the data stored in the print buffer, and then starts a new line according to the
defined amount of paper feed for one line.
Details • After executing this command, a head of a line is set as a starting position of
printing.
• LF command received immediately following CR is ignored.
• The amount of paper feed for one line is fixed at 24-dot pitch.
SO Double–Width Printing Mode Specify
Code 0E
16
Function Specifies the double −width printing. Hereafter, the width of characters to be printed
is doubled.
Details • This command is not cancelled until either ESC @ or SI command is entered.