Sharp HT-X1 - Manual (Page 49)

49
HT-X1
Adv
anced F
eatures
" Audio Signal/Speaker Indicators
Audio signal indicators light up for the corresponding audio source,
and speaker indicators are illuminated according to signals sent to
the speakers.
Example:
When 2.1 channel audio signals (L, R, LFE) are received, the audio
signal indicators "L", "R" and "LFE" light up.
The illustration below indicates that 2 channel stereo sound (L and
R) is reproduced.
2 channel stereo sound is converted to 5.1 channel surround sound,
and all the speaker indicators "
" light up.
Audio Signal/Speaker Indicators:
Notes:
! You can switch the audio output when the disc contains sounds
of multiple audio formats (Dolby Digital, DTS, etc.). See page 34.
! Sound may not be produced from the subwoofer/amplifier unit
depending on the disc.
! You cannot change the multi channel mode or stereo mode while
listening to the radio.
! If sound is unpleasant to listen to, change the multi channel mode
or stereo mode.
! Settings for the multi channel mode and stereo mode are
retained by input (DVD, AUX DIGITAL and AUX ANALOG). When Dolby Pro Logic is activated
(2) (1) (3) (4) (6) (5)
(8)
(10) (11) (9)
(7)
(12) (13)
Audio signal indicator
Speaker indicator
L, R, LFE: Incoming audio signals
" " appears when the speakers are
receiving audio signals.
(1)Left Front Speaker Indicator
(2)Left Indicator
(3)Center Indicator
(4)Center Speaker Indicator
(5)Right Indicator
(6)Right Front Speaker Indicator
(7)Low Frequency Effect Indicator
(8)Surround Monaural Signal Indicator
(Lights up when the surround speakers receive monaural sig-
nals.)
(9)Left Surround Speaker Indicator
(10)Left Surround Indicator
(11)Subwoofer Indicator
(12)Right Surround Indicator
(13)Right Surround Speaker Indicator