Sharp HT-X1 - Manual (Page 47)

47
HT-X1
Radio
" Memorizing a station
You can store 40 AM and FM stations in memory and recall them at
the push of a button. (Preset tuning)
Note:
The backup function protects the memorized stations for a few
hours should there be a power failure or the AC power cord get dis-
connected.
" To recall a memorized station
To select a preset station with the direct number buttons:
Example:
To select 28, press "2", "8" and "ENTER".
" To scan the preset stations
The stations saved in memory can be scanned automatically. (Pre-
set memory scan)
" To erase entire preset memory
1 Perform steps 1 - 3 in "Tuning" on page 46.
2 Press the ENTER button to enter the preset tuning saving
mode.
3 Within 5 seconds, press the TUNER PRESET ( or ) but-
ton to select the preset channel number.
Store the stations in memory, in order, starting with preset
channel 1.
4 Within 5 seconds, press the ENTER button to store that
station in memory.
If the "PROGRAM" and preset number indicators go out before
the station is memorized, repeat the operation from step 2.
5 Repeat steps 1 - 4 to set other stations, or to change a pre-
set station.
When a new station is stored in memory, the station previously
memorized will be erased.
Press the TUNER PRESET ( or ) button for less than 0.5 sec-
onds to select the desired station.
1 Press the corresponding number ("0" - "9").
2 Press the ENTER button.
1 Press the TUNER PRESET ( or ) button for more than 0.5
seconds.
The preset number will flash and the programmed stations will be
tuned in sequentially, for 5 seconds each.
2 Press the TUNER PRESET ( or ) button again when the de-
sired station is located.
1 Hold the CLEAR button down for 4 seconds or more.
2 Within 10 seconds, press the ENTER button.