Sanyo POA-MD13NET2 - Manual (Page 68)

68
Chapter 6 Use of Serial Port
Control the projector with Telnet
This product allows you to control the projector by using the Telnet application.
Normally, it is used for controlling the external equipment connected to the serial port
and also control the projector itself by specifying the telnet port no.10000.
* It is not affected by the serial port setting of the projector when using the telnet appli-
cation.
In the step 2 of the previous page, enter port no. “10000” after the IP address no.
> open 192.168.1.201 10000 return
* Use the IP address
assigned to the pro-
jector
After the communication is established, type the password and the command for
controlling the projector and then enter “Enter” key.
The right table shows the typical command lists for controlling the our projector and
please consult your local dealer for further information of another commands.
Command Function
C00 Turn the projector on
C01 Turn the projector off
C05 Selects input1
C06 Selects input2
C07 Selects input3
C08 Selects input4
C09 Volume up
C0A Volume down
C0B Mute on
C0C Mute off
C0D Video mute on
C0E Video mute off
C1C Menu display on
C1D menu display off
Command list table