Sony DVW-250 - Manual (Page 41)

This section describes how to prevent inadvertent
operations during recording, and how to carry out the
actual recording.
The recording procedure depends on whether or not
the CAMERA connector was selected in the procedure
described in the section "Selecting the input video
signal" (page 4-3).
Preventing inadvertent operations
To prevent an unintended operation from affecting the
unit, during recording normally the operation of all
controls except the STOP and PAUSE buttons is
inhibited.
To prevent even the STOP and PAUSE buttons from
operating, switch the KEY INHI switch to ON after
starting recording.
At the end of recording, return the KEY INHI switch
to OFF, then press the STOP button.
Recording the input signals from the
CAMERA connector
Recording video and audio
(signals input from the CAMERA connector)
1 Switch the POWER switch on, and load a cassette.
2 Hold down the REC button, and press the PLAY
button.
3 Press the PAUSE button on the DVW-250/250P or
the VTR START button on the camera.
Recording starts.
4 To end recording, press the STOP button.
Pausing recording
• After starting recording with the VTR START
button on the camera: press the VTR START
button on the camera once more. In this case the
PAUSE button on the DVW-250/250P does not
operate.
• After starting recording with the PAUSE button
on the DVW-250/250P: press the PAUSE button or
the VTR START button on the camera. In either case
the PAUSE indicator flashes, and the DVW-250/
250P enters the paused state. To restart recording,
press the VTR START button on the camera or the
PAUSE button on the DVW-250/250P.
Chapter 4 Recording 4-13