Sony DVW-250 - Manual (Page 21)

This unit can operate from any of the following power
sources:
• BP-90A nickel-cadmium battery pack
• BP-L60 lithium ion battery pack
• Supply to the DC IN 12V connector, for example
using an AC-550/550CE AC Adaptor.
Using a BP-90A Battery Pack
A BP-90A Battery Pack provides about two hours of
' continuous recording (when the unit is operated with
the MODE switch in the SAVE position, the CONFI
switch in the OFF position, and the setup menu item
"SDI OUT" set to "OFF").
Before use, charge the battery pack using a BC-410/
410CE Battery Charger. Charging takes about two
hours thirty minutes.
For details of charging, see the instructions provided with
theBC-410/410CE.
Inserting the BP-90A Battery Pack
Use the following procedure.
The adhesive label bound into the end of this book
gives directions for replacing the battery pack. You
can attach it to the cover of the battery pack
compartment for reference.
1 Open the cover of the battery
pack compartment.
2 Fold down the upper and lower
divider grids inside the battery
c o m p a r t m e n t by pulling down
the upper one, then insert the
battery pack with the end with
the lead attached toward you.
3 Plug the lead into the
connector inside the battery
pack compartment, and tuck
the lead completely into the
compartment.
4 Close the cover of the battery
pack compartment.
Chapter 3 Getting Started 3-1