Sanyo POA-HDTM01 - Manual (Page 28)

1/1: Output Level Select
Noise or interference may appear on images of some projectors when using in the
broadcast mode depending on whether the signal reception level of receiver is too high or
low. Try to adjust the output level of the transmitter to get the best reception condition for
all projectors.
1. Press the MENU button to show the Menu. Press the Point de buttons to select Main
Menu "1/6: Broadcast Mode Setup" Menu and then press the SELECT button.
2. Press the Point de buttons to select Sub Menu "1/1: Output Level Select" and then
press the SELECT button.
3. Press the Point 7 8 buttons to select the Output Level (1 to 5) and then press the
SELECT button to perform the adjustment.
1 . . . . . .minimum output level
5 . . . . . .maximum output level
Output Level
5
Output Level
1
Output 1/1
Level Select
Broadcast 1/6
Mode Setup
TRANSMITTER
Broadcast Mode Operation