Sanyo POA-HDTM01 - Manual (Page 24)

TRANSMITTER
Single Mode Operation
When changing a pair of transmitter and receiver
If you want to communicate with the other receiver, you should reset the current
authentication.
Main Menu 6/6: Mode Select
If not set to the Single Mode, set to the Single Mode. Refer to page 22.
Main Menu 1/6: Single Mode Setup
a Sub Menu 2/2: Initialize
1. Press the MENU button to show the Menu. Press the Point de button to select Main
Menu 1/6: Single Mode Setup and then press the SELECT button.
2. Press the Point de buttons to select Sub Menu 2/2: Initialize and then press the
SELECT button.
3. Press the Point 7 8 buttons to move the bracket to [YES] and then press the SELECT
button to perform the initialization.
Main Menu 1/6: Single Mode Setup
a Sub Menu 1/2: Authentication
Perform the Authentication again. Refer to page 22.
Authentication
[YES] NO
Authentication
YES [NO]
Authenti- 1/2
cation
Please wait...
SingleMode 1/6
Setup
Initialize 2/2 Initialize
[YES] NO
Success
Failure
SingleMode 1/6
Setup