Sanyo POA-HDTM01 - Manual (Page 15)

English
1
HD DATA WIRELESS TRANSMITTER BOX
OWNER'S MANUAL
This transmitter uses nominal input
voltages of 100–120 V or 200–240 V AC.
- The AC outlet must be near this
equipment and must be easily
accessible.
- Use only the supplied AC
adaptor, and do not use any
other AC adaptor. Otherwise, a
malfunction may occur.
Connect the AC adaptor with following
steps q to e.
When disconnecting, reverse the order.
✔ Note:
- Be sure to turn off the transmitter, before
disconnecting the AC power cord.
- Unplug the AC power cord when the
transmitter is not in use. When the
transmitter is connected to an outlet with
the AC power cord, it is in stand-by mode
and consumes a little electric power.
DC16V 2.5A
Note on the AC Power Cord
AC power cord must meet the requirements of the country where you use the transmitter.
Confirm the AC plug type with the chart below and proper AC power cord must be used. If
the supplied AC power cord does not match your AC outlet, contact your sales dealer.
AC adapter side AC outlet side
For the U.S. and
Canada
For Continental
Europe
For the U.K.
To the AC outlet
(120 V AC)
To the AC outlet
(200 - 240 V AC)
To the AC outlet
(200 - 240 V AC)
q
w
e
AC adaptor
AC power cord
Installation
Connecting the AC Power Cord