Setting the print mode -19, Configuring the paper sensor -19, Configuring the paper sensor type -19 – SATO GT424 User Manual
Page 55: 7 setting the print mode, 8 configuring the paper sensor, 9 configuring the paper sensor type
Section 3: Configuration and Operation
GT Series Operator’s Manual
Page 3-19
3.9.7 Setting the Print Mode
The printer can be switched to operate in Thermal Transfer or
Direct Thermal mode with this setting.
Press the
/
buttons to select the TRANSFER or DIRECT
option. The default value is TRANSFER.
Press the ENTER button to confirm the setting and proceed to the
next screen.
3.9.8 Configuring the Paper Sensor
The printer can be switched to operate in Thermal Transfer or
Direct Thermal mode with this setting.
Press the
/
buttons to select the TRANSFER or DIRECT
option. The default value is TRANSFER.
Press the ENTER button to confirm the setting and proceed to the
next screen.
3.9.9 Configuring the Paper Sensor Type
This setting specifies which paper sensor is to be used: Gap
sensor (penetration sensor) and I-Mark sensor.
Press the
/
buttons to select between I-Mark or GAP
settings. The default value is I-MARK.
Press the ENTER button to confirm the setting and proceed to the
next screen.