SATO GT424 - Manual (Page 151)

Section 7: Optional Accessories
GT Series Operator’s Manual Page 7-3
7.3 PCMCIA MEMORY CARTRIDGE
The GT series features a memory cartridge slot for the addition of optional memory cartridges
that are purchased from SATO.
The memory cartridge slot is located behind a protective cover found within the printer’s media
storage area. Memory cartridges of up to 24 MB can be installed for the storage of user data and
graphics.
7.3.1 Installing the memory card
1. Lift up the front cover.
2. Tilt the knob of the memory cartridge
cover inside and remove the memory
cartridge cover.
3. Insert the memory cartridge.
4. Press the knob of the memory car-
tridge cover and press it firmly into
place.
5. Close the front cover. The additional
memory is now ready for use.
6. To remove the memory cartridge,
reverse the procedure described
here.
Caution
• If a memory access command is sent to the printer that does not have a memory cartridge present, an
error will occur. In that case, make sure to install a memory cartridge before issuing any commands to
access a memory cartridge.
• Before installing or removing a memory card, be sure to turn off the printer first.
• To prevent foreign objects and dust from entering the memory card slot, always make sure the memory
card cover is firmly pressed into place, regardless of whether a memory card is installed or not.
Reinsert the cover