Star Micronics SP200F SERIES - Manual (Page 22)

– 19 –
ENGLISH
6. Control Codes
STAR mode
6-1. Control Codes Used in Character Setting
Control codes Hexadecimal codes Function
“R” n 1B 52 n Select international character set. Default is accord-
ing to the dip switch settings 3, 4 and 5.
“M” 1B 4D Select 7
×
7 (Half dots) character size (Default
setting)
“P” 1B 50 Select 9
×
7 (Half dots) character size
0E Select expanded character mode
0F Cancel expanded character mode
(Default setting)
14 Cancel expanded character mode
(Default setting)
“W” “1” 1B 57 31 Select expanded character mode
“W” <1> 1B 57 01
“W” “0” 1B 57 30 Cancel expanded character mode
“W” <0> 1B 57 00 (Default setting)
6-2. Control Codes Used in Print Mode Setting
Control codes Hexadecimal codes Function
“4” 1B 34 Red color print selection (enable for SP216/246)
“5” 1B 35 Red color print deselection (enable for SP216/246)
(Default setting)
“E” 1B 45 Emphasized print mode selection
“F” 1B 46 Emphasized print mode deselection (Default set-
ting)
6-3. Control Codes Used in Line Spacing
Control codes Hexadecimal codes Function
0A Line feed
0D Line feed (same as LF)
“a” n 1B 61 n Feed paper n lines