Star Micronics SP200F SERIES - Manual (Page 102)

– 99 –
APPENDIX
Appendix C: Peripheral Unit Drive Circuit
A drive circuit for driving peripheral units (such as cash drawers) is featured on
the main logic board of this printer. A modular connector for driving peripheral
unit is featured on the output side on the drive circuit. When using this circuit,
connect the cable for the peripheral unit. (Cables must be prepared by the user.)
Note: Peripheral unit drive circuit connector only connects to peripheral units
such as cash drawers, etc.
Do not connect it to a telephone.
Use cables which meet the following specifications.
Note: Pin 1 must be shield drain wire connected to
peripheral device frame ground.
Fig. C-1 Cable specifications
1 Connecting the cable
SERIAL INTERFACE PARALLEL INTERFACE
Separated ground wire is required for Europe only.
Fig. C-2 Connecting the cable
16
Modular plug
Wire lead
Separated Ground wire
connected to shield
(Europe only).
Shield
Manufacturer Model
MOLEX 90075-0007
AMP 641337
JAPAN BURNDY B-66-4
Cable
Separated
Ground wire
Connector for the
peripheral unit drive circuit
Screw
M3x5
Cable
Separated
Ground wire
Connector for the
peripheral unit drive circuit
Screw
M3x5