Symbol Technologies MK1000 - Manual (Page 32)

2-2
MK1000 MicroKiosk Product Reference Guide
Wired Ethernet Setup
The MK1000 can communicate with a host via a wired Ethernet connection (10Base-T
cable).
When communicating in this manner the MK1000 can be powered either using the
MK1000’s power supply connected to an AC outlet, or by receiving Power-over-Ethernet
through the Ethernet cable.
Wired Ethernet: Power via AC Outlet
With this installation option, the MK1000 communicates to the host via a 10Base-T Ethernet
cable and receives power via a power supply plugged into an AC outlet.
To install the MK1000, follow the instructions below.
1. Provide power to the MK1000 using its power supply.
• Insert the round barrel connector at the end of the power supply cable into the
MK1000’s Power port. (See
Figure 1-1 on page 1-3 for port locations.)
• Plug the power supply into a wall outlet.
2. Attach the Ethernet cable.
• Connect the Ethernet cable to the LAN port on the MK1000. (See Figure 1-1 on
page 1-3 for port locations.) Ensure the Ethernet cable is terminated according
to the Ethernet Pin-Outs: Obtaining Power via AC Power Supply described in
Table 2-1 and Table 2-2 .
• Plug the other end of the Ethernet cable into the host system’s LAN port.
3. To mount the MK1000, see Mounting the MK1000 on page 2-11.
After completing the mechanical installation of the MK1000, refer to Chapter 3, Setup and
Installation: Communication to establish communication with the host.