Symbol Technologies MK1000 - Manual (Page 116)

5-14
MK1000 MicroKiosk Product Reference Guide
Button Press - Event Notification
When one of the MK1000 function buttons is depressed, a string is sent to the host where
is the number of the button pressed. For example, "BTN4" is
sent to the host when the right most button, ‘4’, is pressed. This event notification must be
surrounded by the normal framing characters used by the PCK emulation firmware (which
are dependent on communications type described in
Table 5-2 on page 5-3 ).
Button Event Sent to Host RS-232
Scan Engine Commands
Changing the Scanning Mode (Scan Pattern)
To change the scanning mode, the host sends the MK1000 the following command
sequence:
[ s
The following is a list of scanning mode numbers:
To change the scanning mode to Smart Raster, the scanning mode number 1 would be
used.
MK1000 Host
BTN4
Number Scan Mode
1 Smart Raster
2 Always Raster
6 Cyclone Omnidirectional
(1D scanning only)
7 Semi-Omni Pattern