Placing the handset in the charging cradle, Setting the date and time – Siemens Gigaset SL56 User Manual
Page 7
6
First steps
Gigaset SL56 / IM1 EN / A31008-M1752-R111-2-6Z19 / start_guide_time.fm / 24.7.07
Placing the handset in the charging
cradle
¤
Plug the charging cradle mains adapter
into a mains power socket.
¤
Place the handset in the charging cra-
dle with the display facing forward.
To charge the battery pack, leave the
handset in the charging cradle.
For questions and problems see page 25.
Initial charging and discharging of the
battery pack
If the handset is activated, the flashing
battery icon
e in the top right of the dis-
play indicates that the battery pack is
being charged.
During handset operation, the battery
icon indicates the charge status of the bat-
tery pack (page 1). The correct charge sta-
tus can only be displayed if the battery
pack is first fully charged and discharged.
¤
To do this, leave the handset in the
charging cradle continuously for ten
hours. Your handset need not be
switched on for it to charge.
¤
Afterwards, remove the handset from
the charging cradle and do not put it
back again until the battery pack is fully
discharged.
Please note:
u
Always repeat the charging and dis-
charging procedure if you remove the
battery pack from the handset and
insert it again.
u
The battery pack may warm up as it is
charging. This is not dangerous.
u
After a time the charge capacity of the
battery pack will decrease for technical
reasons.
Setting the date and time
The date and time must be set in order to,
e.g. have the correct time for incoming
calls and be able to use the alarm clock
and calendar.
¤
If you have not yet set the date and
time, press the display key
§Time§
to open
the input field.
To change the time, open the input field
via:
w
¢
Ð
¢
Date/Time
¤
Change multiple line input:
Date:
Enter the day, month and year as 8 dig-
its.
Time:
Enter hours and minutes as 4 digits
(e.g.
Q M 1 5 for
07:15 a.m.
§Save§
Press the display key
If the handset is registered and the time
has been set, the idle display is as follows,
depending on the base station (example):
Your handset is now ready for opera-
tion!
Notes:
– If the handset has switched itself off
because the battery pack is flat and is then
placed in the charging cradle, it will switch
itself on automatically.
– Only place the handset in the charging cra-
dle that is intended for it.
Note:
After the first battery charge and discharge,
you may replace your handset in the charging
cradle after every call.
Ð
V
INT 1
15.11.05
07:15
?
SMS