Siemens Gigaset SL56 - Manual (Page 6)

5
First steps
Gigaset SL56 / IM1 EN / A31008-M1752-R111-2-6Z19 / start_guide_time.fm / 24.7.07
¤
Then press it into the housing from
above until the bracket on the side of
the battery back snaps securely into the
housing.
Please note:
To remove the battery pack, you must first
press the bracket on the side.
Closing the battery cover
¤
First, align the notches on the side of
the battery cover with the protrusions
on the inside of the housing.
¤
Then press the cover until it clicks into
place.
Attaching the belt clip
There are notches for attaching the belt
clip on the side of the handset at the same
height as the display.
¤
Press the belt clip onto the back of the
handset so that the protrusions on the
belt clip engage with the notches.
Opening the battery cover
¤
If fitted, remove the belt clip.
¤
Lift the device with the keypad in the
palm of your hand.
¤
Insert your index finger into the notch
on the lower edge.
¤
Carefully lift the cover upwards out of
the notches.
Registering the handset
A Gigaset SL56 handset can be registered
to up to four base stations.
You must initiate handset registration on
the handset and on the base station.
After it has registered, the handset returns
to idle status. The internal number of the
handset appears in the display, e.g. INT 1 .
If it does not, repeat the procedure.
On the base station
To find out how to register the handset on
the base station, see the user guide for the
base station.
On the handset
w
¢
Ð
¢
Handset
¢
Register H/Set
s Select base station, e.g. Base
1 , and press §OK§ .
~ Enter the system PIN for the
base station and press §OK§
(depending on the base sta-
tion). The following flashes in
the display, e.g. Base 1 .