Siemens Gigaset SL56 - Manual (Page 26)

25
Appendix
Gigaset SL56 / IM1 EN / A31008-M1752-R111-2-6Z19 / start_guide_time.fm / 24.7.07
Appendix
Care
Wipe the base station, charging cradle and
handset with a damp cloth (do not use
solvent) or an antistatic cloth.
Never use a dry cloth. This can cause
static.
Contact with liquid
If the handset has come into contact with
liquid:
1. Switch off the handset and remove
the battery pack immediately.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place for at least 72 hours (not
in a microwave, oven etc.).
4. Do not switch on the handset again
until it is completely dry.
When it has fully dried out, you will nor-
mally be able to use it again.
Questions and answers
If you have any questions about using
your handset, visit us at any time at
www.siemens.com/gigasetcustomercare.
The table below contains a list of common
problems and possible solutions.
Service (Customer Care)
We offer you support that is fast and tai-
lored to your specific needs!
Our Online Support on the Internet can be
reached any time from anywhere.
http://www.siemens.com/gigasetcustom-
ercare
It provides you with 24/7 support for all
our products. It also provides a list of FAQs
and answers plus user guides and current
software updates (if available for the prod-
uct) for you to download.
You will also find frequently asked ques-
tions and answers in the appendix of this
user guide.
The display is blank.
1. The handset is not switched on.
¥
Press and hold the end call key
a
.
2. The battery pack is flat.
¥
Charge/replace the battery pack
(page 4).
The handset does not respond to a key press.
The keypad lock is activated.
¥
Press and hold the hash key
#
(page 8).
!
"Base station x" is flashing in the display.
1. The handset is outside the range of the base
station.
¥
Reduce the distance between handset/
base station.
2. The handset has been de-registered.
¥
Register the handset (page 5).
3. The base station is not switched on.
¥
Check the base station mains adapter.
Base Search is flashing in the display.
The handset is set for Best Base and no base sta-
tion is switched on or within range.
¥
Reduce the distance between handset/base
station.
¥
Check the base station mains adapter.
Handset does not ring.
The ringtone is switched off.
¥
Activate the ringtone (page 18).
The other party cannot hear you.
You have pressed the
u
(INT) key. The hand-
set is "muted".
¥
Switch on the microphone again (page 8).
You hear an error tone when keying an input
(a descending sequence of tones).
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the instruc-
tions if necessary.