User programs – Sharp AR-201 User Manual
Page 40
38
GENERAL INFORMA
TION
USER PROGRAMS
4
Select the desired parameter using the numeric keys.
●
The entered parameter number will blink on the right side of the copy
quantity display.
●
The parameters are shown in the table below.
For example, to change the setting of the auto power shut-off timer to
60 min., press key 2.
5
Press the START (
) key.
●
The right-hand number in the copy quantity display will be steadily lit
and the entered value will be stored.
6
To continue with other user programs, press the
key
and then repeat steps 2 to 5. To exit the user program
mode, press the light (
) key.
●
All the alarm indicators will go out.
User programs
Program name
Parameters
Auto clear time
0
OFF
1
30 sec.
* 2
60 sec.
3
90 sec.
4
120 sec.
5
10 sec.
Preheat mode**
0
OFF
** 1
30 sec.
2
60 sec.
* 3
90 sec.
4
120 sec.
Auto power shut-off timer
* 1
30 min.
2
60 min.
3
90 min.
4
120 min.
5
240 min.
Stream feeding mode
* 0
OFF
1
ON
Auto power shut-off setting
0
OFF
* 1
ON
Border line for 2 in 1 or 4 in 1 * 0
OFF
1
ON
Rotation copy
0
OFF
* 1
ON
Auto paper select mode
0
OFF
* 1
ON
Auto tray switching
0
OFF
* 1
ON
Erase width adjustment
0
0 mm
1
5 mm
* 2
10 mm
3
15 mm
4
20 mm
( 0
0"
1
1/4"
* 2
1/2"
3
3/4"
4
1")
Layout in 2 in 1 copy
* 1
Pattern 1
2
Pattern 2
Layout in 4 in 1 copy
* 1
Pattern 1
2
Pattern 2
3
Pattern 3
4
Pattern 4
Offset of paper output tray
0
Upper OFF, lower OFF
* 1
Upper ON, lower ON
2
Upper ON, lower OFF
3
Upper OFF, lower ON
Factory default settings are indicated with an asterisk (*). For layout in 2 in 1 copy and 4 in 1 copy, see page 63.
** In European countries, the default setting of the preheat mode is 1 (
30 sec.). For other programs, factory default settings
in these countries are same to those shown above with an asterisk (*).
If you select “0” (OFF) in a program, the corresponding
function will be disabled.