Sharp AR-201 - Manual (Page 30)

28
ST
A
TUS
INDICA
T
ORS
1 Open the bypass tray. Lift slightly on the side cover
and slide the cover out until it stops.
2 Push gently on both sides of the front cover to open the
cover.
3 Push the toner cartridge lock release lever and pull the
toner cartridge out. Remove the toner cartridge while
supporting it with the left hand at the green label position.
● For disposal of the old toner cartridge, contact your dealer.
4 Remove the new toner cartridge from the bag. Hold the
cartridge on both sides and shake it horizontally four or
five times.
TONER CARTRIDGE REPLACEMENT
When the toner cartridge replacement required ( ) indicator lights up,
replacement of the toner cartridge will be needed soon. Obtain a new
cartridge.
When the toner cartridge replacement required ( ) indicator blinks, the
tonesr cartridge must be replaced before copying can be resumed. Replace
the toner cartridge by following the procedure below.
For best copying results, be sure to use only
SHARP products.
The package of SHARP toner has the Genuine
Supplies label.
Toner cartridge replacement
Toner cartridge lock
release lever
4 or 5 times
GENUINE SUPPLIES
During a long copy run of a dark original, the
indicator may blink and the copier stop, even though
toner is left. The copier will feed toner up to 2 minutes
and then the START key (
) indicator will light up.
Press the START ( ) key to restart copying.