Sanyo ECO R410A User Manual
Page 47

47
Troubleshooting
If your air conditioner does not work properly, first check the following points before requesting service. If it still does not work
properly, contact your dealer or a service center.
■
Do not block the air intake and outlet of the unit. If either is obstructed, the
unit will not work well, and may be damaged.
Do not let direct sunlight into the room. Use sunshades, blinds or curtains.
If the walls and ceiling of the room are warmed by the sun, it will take longer to
cool the room.
•
•
Avoid
Trouble
Possible Cause
Remedy
Air conditioner does not run at all.
1. Power failure.
2. Leakage circuit breaker has
tripped.
3. Line voltage is too low.
4. Operation button is turned off.
5. The wired remote control unit or
heat pump is malfunctioning. (The
inspection mark and the letters
E, F, H, L, P in combination with
numbers appear on the LCD of
the wired remote control unit.)
1. After a power outage, press ON/
OFF operation button on the wired
remote control unit.
2. Contact service center.
3. Consult your electrician or dealer.
4. Press the button again.
5. Consult your dealer.
Compressor runs but soon stops.
1. Obstruction in front of condenser
coil.
1. Remove obstruction.
Poor cooling (or heating) perfor-
mance.
1. Dirty or clogged air filter.
2. Heat source or many people in
room.
3. Doors and/or windows are open.
4. Obstacle near air intake or air dis-
charge port.
5. Thermostat is set too high for
cooling (or too low for heating).
6. (Defrosting system does not
work.)
1. Clean air filter to improve the air-
flow.
2. Eliminate heat source if possible.
3. Shut them to keep the heat (or
cold) out.
4. Remove it to ensure good airflow.
5. Set the temperature lower (or
higher).
6. (Consult your dealer.)
Tips for Energy Saving
■
Always try to keep the air filter clean. (Refer to “Care and Cleaning”.) A clogged
filter will impair the performance of the unit.
To prevent conditioned air from escaping, keep windows, doors and any other
openings closed.
•
•
Do
NOTE
Should the power fail while the unit is running
If the power supply for this unit is temporarily cut off, the unit will automatically
resume operation once power is restored using the same settings before the
power was cut off.