Smeg CS150SA - Manual (Page 17)

19
Instructions for the User
5.3 Setting the time
When the oven is used for the first time, or after an interruption in the
electricity supply, the displays flash at regular intervals. These two
displays are synchronised; to set the time simply adjust one of them,
remembering that future adjustments to the time must be made on the
display just set.
Press the key for 1 / 2 seconds to stop the display flashing and start
the procedure for setting the current time. Press the value modification
keys or to increase or decrease the setting by one minute for each
pressure.
Press one of the two value modification keys until the current time
appears. 6/7 seconds after the last key is pressed, the clock will start from
the time set.
At the end of each programmed operation 8 beeps will sound 3/4 times at
intervals of about 1 and a half minutes. This sequence can be stopped at
any time by pressing any key.
5.4 Minute-Minder
• This function does not stop cooking; it simply activates the buzzer.
Press the key and the display will light up as shown in figure 1;
• Within 6/7 seconds, press the or keys to set the minute-minder.
Each time a key is pressed, 1 outside segment, representing 1 minute
of cooking time, will light up or go out. (figure 2 shows a cooking time
of 10 minutes).
• 6/7 seconds after the last key is pressed, the countdown will start;
when it finishes, the buzzer will sound.
• During the countdown, the current time can be viewed by pressing the
key once; press it again to return to the minute minder display.
• At the end of the countdown, the oven must be switched off
manually by turning the thermostat and function selector knob to
0.